Delta T Industries & Dryers

The Delta T has been applied to following
products and dryer-types: 

Corn gluten - (Flash dryers (Ring))

Fiber (animal feed) – Rotary dryers

Dry Pet food - 2-pass belt dryers.

Parmesan cheese – Fluidized-bed dryer

Instant coffee – Spray dryers

Coffee beans – Rotary dryers

Cranberries – Belt dryers

Cooked rice – Belt dryer

Dry Cereal - Belt and rotary dryers

Citrus Peel – Rotary dryer

Bacon bits – Belt dryer

Pretzels – Belt dryer

Beef Jerky (pet food) – Semi-batch dryer

Ceiling tile – Belt dryer

Wood veneer – Jet Impingement and longitudinal conveyor dryers

Lumber – Multi-zone (batch) steam heated kilns & direct-fired kilns

Medium Density Fiberboard (MDF) – Flash dryer

Oriented Strand board (OSB) – Rotary and Conveyor dryers

Ceramics – Spray dryer

Minerals - Nickel ore – Rotary dryer

Sodium silicate – Spray dryer

Calcium Carbonate – Rotary dryer

Sand – Rotary dryer

Calcium Hypochlorite – Rotary dryer

Magnesium Sulfate – Rotary dryer

Tobacco – Fluidized-bed dryer

Carpet – Conveyor dryer

Carpet coater – Conveyor dryer

Textiles – Loop & Tenter Frame dryers

Rayon fiber – Belt

Cotton Fiber - Belt

DELTA T PRODUCTS

The Delta T moisture/dryer control system is based on a unique, patented,  award-winning “inside-the-dryer” moisture sensor that reduces the moisture variation at least 30 %.   This reduction in moisture variation   produces significant improvements in product quality (elimination of over and under-dried product), productivity, and energy conservation.  Payout of system is less than one year.

Delta T Moisture/Dryer Control System:  usually reduces moisture variation a minimum 30 % and sometimes more, and where applicable, allows an increase in the exiting product mean moisture content without exceeding the upper specification limit.

Water Activity Option:  Improved moisture control enables control of water activity for applicable products to prevent the proliferation of mold and other harmful microorganisms.

Warp Control:  Since CD warp during manufacture of corrugated board  is primarily the result of imbalance in moisture between the bottom and top liner boards, control of liner board moisture from the pre-heaters using a new Delta T moisture control development especially corrugators, should significantly reduce CD warp.

Lime Kiln Control:  The quality of burnt lime produced in a Kraft paper mill recovery process can be improved by using Delta T  technology for controlling the moisture content of the mud inside the kiln or in a fluidized-bed.